If we decide this build is doable and a "go" there are many ways to go with it. If we are going to get Gene Beal to make a custom pair of grips to match (close to match) a Randall knife handle there will be some things that need to be addressed.

A) Certain materials are difficult if not almost impossible to use. Musk ox, for example, as has already been documented is more likely to shrink when applied as scales on something. (It can shrink other ways also, but more trouble has been reported on scales)
B) Some exotic woods work well on solid handles but get a bit brittle for scales causing slight chips / checks around the edges.
C) Expense! Musk ox scales long and thick enough for a Randall and grips would run hundreds of dollars depending upon what knife we choose. The same with ivory, but not quite as bad.
Having worried ya'll with all of the above, I should tell you that many...many possibilities exist. I am excited about this if you folks think we should proceed. I would like to hear from you and specifically hear your ideas for Randall knife model and handle material!
Best, Capt. Chris