Hi Ron, thanks, glad you like it. I spend a lot of time in my shop - about 14 to 16 hours a day, mostly on orders, that range from small folders to broad swords, but I leave a few hours at the end of each day for my projects and custom knives I like to make, and that is where this one fits in. It is actually not a very difficult or complicated knife to make, so it goes quite quickly all and all.

The fillet is there - it is just not too clear - I will try and take some better pics a little later. I also used an industrial epoxy on the tang, as well as pinning it, so despite it being a real slim and slick little B&T, it is a very strong little knife too

I will try and get to the sheath too today, and post up pics later.