3/16 vs 1/4 question, #4 & #15CDT - Knifetalk Forums

The RANDALL KNIFE FORUMS

A place where EVERYBODY is welcome to join in on the discussion of Randall Made knives

You are not logged in. [Log In] Knifetalk Forums » Forums » Randall Knife Talk » Randall Made Knives » 3/16 vs 1/4 question, #4 & #15CDT

Topic Options

Rate This Topic

#194841 - 07/22/21 07:50 PM Re: 3/16 vs 1/4 question, #4 & #15CDT [Re: eLarry]
Dirty_Water Knife Enthusiast Registered: 09/13/05 Posts: 2261 Loc: central fl.	We start with steel measured at a little over 1/4" stock...but after 3-4 shapings and just as many sandings and polishings it may be a touch under... _________________________ ---DW--- Scott RKS #014 HE IS RISEN!, HE IS RISEN INDEED!
Top

View All Topics

Entire topic
Subject	Posted by	Posted
3/16 vs 1/4 question, #4 & #15CDT	eLarry	07/22/21 06:42 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	Dirty_Water	07/22/21 07:50 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	eLarry	07/22/21 08:18 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	Dirty_Water	07/23/21 08:06 AM
Re: 3/16 vs 1/4 question, #4 & #15CDT	eLarry	07/23/21 08:59 AM
Re: 3/16 vs 1/4 question, #4 & #15CDT	LarryWW1246	07/23/21 10:43 AM
Re: 3/16 vs 1/4 question, #4 & #15CDT	pappy19	07/23/21 11:28 AM
Re: 3/16 vs 1/4 question, #4 & #15CDT	LarryWW1246	07/23/21 12:00 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	thevalueman	07/23/21 12:58 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	eLarry	07/23/21 06:30 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	LarryWW1246	07/23/21 08:07 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	eLarry	07/24/21 06:20 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	Dirty_Water	07/24/21 07:51 PM
Re: 3/16 vs 1/4 question, #4 & #15CDT	eLarry	07/24/21 08:50 PM

Hop to:

Moderator: Mr_Mod