I have been dragging knives out that I may not have posted before. I bought this from the shop, but did not know any better to order a sheath for it too. Peter
Registered: 09/25/13
Posts: 1115
Loc: the other side of the earth
On TV yesterday they showed the old movie "best of the best 3", at the very end, a rather familiar silhouette appeared for a few seconds. Possibly a copy as it doesn't look like it's polished. Seeing him there is quite unexpected.
Attachments
------
_________________________
Si vis pacem, para bellum
Registered: 11/13/10
Posts: 3
Loc: The Jersey Shore
This is my first time posting here. I have a #9 Pro Thrower that measures 11-7/8” x 3/16” thick and haven’t seen any others like it. Would anyone know why it is this length instead of 9”? Also, is there any reason why the stamp is inverted? Thanks for your help and thank you for this site. Alex
Registered: 09/19/05
Posts: 1369
Loc: East Tincup General Store,Colo...
I think the Model 9 had a variety of sizes and shapes with the Shop experimenting. I had one that had the inverted stamp, so I don't think it was too unusual.
_________________________
David Loomis RKS# 724 RKCC# CM-061 Molon Labe
Registered: 09/19/05
Posts: 1369
Loc: East Tincup General Store,Colo...
Originally Posted By: trimmer
Thank you for that info. About when do you think it was made? Alex
I don't know. When I tried to get an estimate on the one I owned, it was difficult to pin down. Maybe some of the gurus could give a ballpark figure for even which decade.
_________________________
David Loomis RKS# 724 RKCC# CM-061 Molon Labe