OK, Crew:
A "Small Gambler" comes with a lot of tricks right from the Get-go!
* Stainless
* Thumb notches
* Nickel silver reduced hilt
* Black micarta handle (concaved)
* Pouch sheath (with boot clip)
It (along with the Model #24, Guardian) do require a specific handle "size" when ordering with "CW" (Customer's supplied handle material). The material has to be as follows:
3/4" x 1 1/4" x 4 1/8". I have some very large blocks (only a couple) of orange G-10. They were cut to fit the larger Randall Model #12's and can be cut down to this specific size. The Randall shop will not mess with cutting down G-10 material. It's so tough on belts, blades and drill bits that the exact size material needs to be submitted.
I am only bringing this information up to enlighten folks who were not aware of this and to let you understand that all of the above means this knife will not be cheap. As of July 1st the shop will charge $80 to install G-3 or G-10 handle material.
OK: Enough of that. Let's figure out how we're gonna finish this Biker Build>
Thanks, Capt. Chris
Previous Topic
Index
