Handle Material - Knifetalk Forums

The RANDALL KNIFE FORUMS

A place where EVERYBODY is welcome to join in on the discussion of Randall Made knives

You are not logged in. [Log In] Knifetalk Forums » Forums » Randall Knife Talk » Randall Made Knives » Handle Material

Page 2 of 2

2

Topic Options

Rate This Topic

#199634 - 07/13/22 08:41 AM Re: Handle Material [Re: thevalueman]
Captain Chris Stanaback Knife Enthusiast Registered: 09/14/05 Posts: 12677 Loc: Central Florida	Tom's CW...after I reduced the size...considerably! Stay Sharp, Capt. Chris Attachments ------ _________________________ Capt.Chris Stanaback RKCC/RKCA Founder RKS #016 NRA Lifetime Member CAPTSTANABACK@aol.com WEBSITE: www.captstanaback.com
Top

#199641 - 07/13/22 05:59 PM Re: Handle Material [Re: Captain Chris Stanaback]
thevalueman Knife Enthusiast Registered: 02/04/08 Posts: 2832 Loc: Georgia	still...that's a sharp photo!! :-)Rocky _________________________ Rocky Whitaker RKCC#25
Top

#199645 - 07/13/22 08:56 PM Re: Handle Material [Re: thevalueman]
tomthbomb Knife Enthusiast Registered: 09/15/05 Posts: 3955 Loc: Deep East Texas	Whoa! Thanks Cap! _________________________ Tom Welch RKS #4868
Top

#200648 - 09/18/22 07:59 PM Re: Handle Material [Re: tomthbomb]
whatsaborcich Knife Enthusiast Registered: 11/30/21 Posts: 10 Loc: PNW	I think that if the Fordite was coated or after shaping with epoxy would help a lot. Or I wonder if it could be put in a pressure pot to fill all the voids. Kajo _________________________ Kajo RKCC #804
Top

#200651 - 09/19/22 07:54 AM Re: Handle Material [Re: whatsaborcich]
LarryWW1246 Knife Enthusiast Registered: 03/20/06 Posts: 1730	Good point. The same process used to stabilize wood.... Has it been done? Larry _________________________ Larry W. Williams RKCC #CM-041 ABKA #046 RKS #1246
Top

Page 2 of 2

2

View All Topics

Hop to:

Moderator: Mr_Mod