Hi I have wanted to build a #16 Diver with an orange handle for years. I found a piece of orange G10 but need to get a slot cut. Can anyone suggest someone who can cut the slot?
If you know anyone with a milling machine, they can do that easily. Machine shops, some gunsmiths and hobbyists could do that for you. If the place where you work has a shop than you might get one of the guys to do it over lunch.
here is mine
Peter
Attachments
------
_________________________
Peter Kaufman NRA Life GOA SAF RKCC CM-023 RKS #5642 SHAG # 005 Ironwood Nut Life is too short to have ugly knives
Registered: 03/25/06
Posts: 832
Loc: Tennessee, USA
Before you start cutting your G10 block...I would contact the RMK shop and and get exact measurement's they will accept..length, width and depth of the slot...and specify what RMK it will be used for.....just sayin'.
_________________________
Rex Buckner RKS ~ 5119 RKCC ~ CM-013
slotted material(suitable for a Randall) is not similar in dimension to non slotted material BUT...if your going to get a shop to cut the "slot" I'm sure they could do the rest of the forming I gave my last orange slotted away....right?? then, when I needed one....I ran across a generous fellow that visits this site on occasion that reciprocated my kindness....what goes around....comes around :-)Rocky